Экскаватор вольво 210 мануал

• Contents

• Table of Contents

• Bookmarks

• 201, Volvo EC210B LI S80303 S80304 Service and maintenance Track slack 199 Tightening track shoe bolts Check the shoe bolts daily. If track shoe bolts (1) are loose, the track shoes are likely to be damaged. Therefore check for looseness and tighten the bolts to specified torque, 85 ± 5 kgf.m. Retightening After tightening with a torque of 85±5 kgf.m check whether the nut and the shoe are …

• 108, Operating instructions 106 Counterweight installation Counterweight installation Standard machine WARNING! Move the safety locking lever down to lock the system securely, See Safety locking system on page 81. and attach a warning tag (do not start the engine) to the left operating lever. Personal injury can occur from a counterweight falling during installation. Do no…

• 136, Operating instructions 134 Escaping from swampy ground Escaping from swampy ground Be very careful when working on swampy ground. In case one track gets bogged If one track gets bogged down, raise this track using the bucket and put a plank under the track. IMPORTANT When raising the machine using boom or arm, use the bottom of the bucket. (Do not use the bucket teeth.) Set the angle be…

• 43, Volvo EC210B Presentation General information 41 General information The USA federal clean air act The Federal Clean Air Act Section 203 (a) (3) prohibits the removal of air pollution control devices or the modification of an EPA certi- fied non road engine to a non certified configuration. The Federal regulations implementing the Clean Air Act for non road engines, 40 C.F.R. Section 89.1003(a)(3)(i)…

• 211, Service and maintenance Periodic replacement of safety critical parts 209 Periodic replacement of safety critical parts To ensure safety at all times when operating or driving the machine, the operator of the machine must always carry out periodic maintenance. To further improve safety, the operator should also carry out periodic replacement of the part…

• 157, Volvo EC210B Safety when servicing Measures to prevent fire 155 Check list If a machine has been damaged by fire or been exposed to in- tense heat, the following protective measures must under all circumstances be followed: Use thick, protective gloves made of rubber and wear goggles which are certain to protect your eyes. As a precaution, seals (0-rings and other oil seal…

• 141, B Operating instructions Lifting objects 139 Lifting objects If the machine is used to lift objects within an area that is governed by the European Machinery Directive 98/37/EC and its amend- ments, the machine must be equipped with following safety work- ing devices. • A load hooking device. • Hose rupture valve on the boom or in some countries hose rup- ture valve on both boo…

• 86, 7 / V Instruments and controls 84 Cab window Glove compartment 1 Glove 2 Latch WARNING! Do not keep tools or a weighty thing in the glove. They can be dropped out of the glove by vibration of the machine or their weights when the equipment is operated, which may cause accidents, perhaps even fatal accidents. Coat hook The coat hook (A) is inside t…

• 91, 3 74 586 1 A’ 2 Instruments and controls Air conditioner/heater (option) 89 5 Diagnosis button When pressing this button, error code of the air conditioning and heating system is shown in display window (3). 6 Compressor ON/OFF switch he cooling system operates only when fan speed control button (9) is ON. 7 Air flow selector button Ventilation is available in four modes.…

• 31, Presentation Plates and decals 29 Long Crawler (LC) Counterweight = 4200 kg Boom = 5.7 m Arm = 3.9 m without bucket Shoe = 600 mm (Unit: kg) R Om 1,5m 3m 4,5m 6m 7,5m 9m 10,5m MR H 7,5m F *3380 (@7272mm) S *3380 6m F *4010 * 3230 (@8256 mm) S 3820 3210 4,5m F *4270 *3220 (@8877mm) S 3740 2790 3m F *6410 *5300 *4750 *3980 *3320 (@9210 mm) s * 6410 508…

• 134, Operating instructions 132 Working with bucket When working, do not Do not strain the slewing mechanism Do not use the slewing force for raking over the ground, demolition of buildings or thrusting bucket teeth into the ground. This opera- tion may cause damage to the machine and attachments. Do not work with the travelling motors Do not dig by using the travelling motors, and thrusting…

• 67, Volvo EC210B Instruments and controls Switches 65 11 Upper wiper switch Position 0 Upper wiper switched OFF Position 1 Upper wiper switched ON intermittently Position 2 Upper wiper switched ON IMPORTANT Lifting the front window while the wiper motor is running, immediately stops the operation. 12 Washer switch Position 0 Washer switched OFF Position 1 Washer switched ON IMPORTANT Neve…

• Operation & Maintenance Manual SWE20F Hydraulic Excavator SUNWARD INTELLIGENT EQUIPMENT CO., LTD. Sunward Intelligent Industrial Park, Xingsha, Changsha, China Sept.2019 …

  SWE20F 2019 104

• PRINTED IN JAPAN (E) 2006, 02ZAXIS850-3 • 850LC-3 • 870H-3 • 870LCH-3 HYDRAULIC EXCAVATOR WORKSHOP MANUALPART NO.W1JB-E-00Workshop ManualURL:http://www.hitachi-c-m.comHydraulic Excavator850-3850LC-3870H-3870LCH-3Service Manual consists of the following separate Part No;Technical Manual (Operational Principle) : Vol. No.TO1JB-ETechnical Manual (Troubleshooting) : Vol. No.TT1 …

  ZAXIS 850-3 16

• U.S.A. :KUBOTATRACTORCORPORATION3401DelAmoBlvd.,Torrance,CA90503,U.S.A.Telephone:(310)370-3370Canada :KUBOTACANADALTD.590014thAvenue,Markham,Ontario,L3S4K4,CanadaTelephone:(905)294-7477France :KUBOTAEUROPES.A.S19-25,RueJulesVercruysse,Z.I.BP88,95101Ar㷅enteuilCedex,F …

  KX080-4 138

• Operator’s Manual © Copyright 2018 — Rail-Ability Limited Page 1 of 71 Conversion Part no. RAA350COPS-001 Issue 1 April 2018 Original Instructions (English) RA350LCSR Atlas Tracked Excavator Operator’s Manual …

  Atlas RA350LCSR 71

E(Z1OB

Ser. No 14132-

VOWO