Мануал honda cbr 125

Ниже представлены прямые ссылки на скачку сервисной документации.

Для Honda CBR125R

• Сервисная информация (Workshop data) на Honda CBR125R
• Сервисный мануал (Service Manual) на Honda CBR125R, 2007

Обзор модели

• Honda CBR125R

Источник — «https://bikeswiki.ru/index.php?title=Honda_CBR125R:_мануалы&oldid=14596»

Категория:

• Сервисная документация

• Contents

• Table of Contents

• Bookmarks

• 45, BODY PANELS/EXHAUST SYSTEM 2-7 INNER COWL REMOVAL/INSTALLATION Remove the screws and inner cowl by pulling it rearward. Install the inner cowl in the reverse order of removal. Insert the tabs of the inner cowl to the slits of the middle cowl and upper cowl. INNER COWL SCREWS TABS SLITS
  …

• 156, FUEL SYSTEM (PGM-FI) 5-64 Install the bank angle sensor with its “UP” mark facing up. Install the bank angle sensor, collars and mounting screw/washers. Tighten the mounting screws to the specified torque. Install the upper cowl (page 2-10). INSPECTION WITH HDS POCKET TESTER Connect the HDS pocket tester (page 5-11). Remove the bank angle sensor (page 5-63). Connect the bank a…

• 154, FUEL SYSTEM (PGM-FI) 5-62 2. Set the connector damper as shown. Then press the quick connect fitting onto the pipe until both retainer pawls lock with a «CLICK». • Align the quick connect fitting with the injector joint. If it is hard to connect, put a small amount of engine oil on the injector joint. 3. Make sure the connection is secure and that the pawls are firmly…

• 32, Honda CBR125R GENERAL INFORMATION 1-28 REAR BRAKE HOSE REAR BRAKE RESERVOIR HOSE DIODE MAIN WIRE HARNESS STARTER MOTOR CABLE GROUND CABLE REAR BRAKE LIGHT SWITCH 2P (NATURAL) CONNECTOR REAR BRAKE LIGHT SWITCH WIRE
  …

• 240, CLUTCH/GEARSHIFT LINKAGE 10-16 Remove the following: – Shift drum stopper plate bolt – Washer – Shift drum stopper plate Remove the dowel pins from the shift drum. INSPECTION Check the return spring and spindle arm spring for fatigue or damage replace them if necessary. Check the gearshift spindle for wear or bend. Check the spindle arm for wear, damage or defo…

• 194, CYLINDER HEAD/VALVES 8-6 CYLINDER COMPRESSION Warm the engine to normal operating temperature. Stop the engine. Remove the spark plug (page 3-9). Install the compression gauge attachment into the spark plug hole. Connect the compression gauge to the attachment. Turn the ignition switch ON (and engine stop switch » «: CM and U type). Shift the transmission into neutral. Crank t…

• 430, Honda CBR125R INDEX 22-2 REAR FENDER····························································· 2-12 REAR MASTER CYLINDER ······································· 15-15 REAR WHEEL ·························································�…

• 17, GENERAL INFORMATION 1-13 COOLING SYSTEM ENGINE REMOVAL/INSTALLATION CYLINDER HEAD/VALVES CYLINDER/PISTON CLUTCH/GEARSHIFT LINKAGE ALTERNATOR/STARTER CLUTCH ITEM Q’TY THREAD TORQUE REMARKS DIA. (mm) N·m (kgf·m, lbf·ft) Water pump impeller 1 7 10 (1.0, 7) Water hose band screw 6 – – See page 6-14 Fan motor shroud mounting bolt 2 6 8.4 (0.9, 6.2) Fan motor …

• 75, Honda CBR125R MAINTENANCE 3-19 Locate the crimped pin ends of the master link from the outside of the drive chain, and remove the link with the drive chain tool set. Remove the drive chain. Include the master link when you count the drive chain links. Remove the excess drive chain links from a new drive chain with the drive chain tool set. Never reuse the old drive chain, m…

• 413, LIGHTS/METERS/SWITCHES 19-21 FUEL LEVEL SENSOR Remove the fuel pump unit (page 5-49). Connect the ohmmeter to the fuel pump unit 5P connector Yellow/white and Green terminals. Inspect the resistance of the float at the full and empty positions. Replace the fuel pump unit assembly if fuel level sensor is out of specification. Install the fuel pump unit (page 5-50). HORN INSPECTION Disconnect the…

• 327, REAR WHEEL/SUSPENSION 14-13 Remove the bolts and chain cover. Remove the screw and brake hose guide. Release the brake hose from the clamp. Remove the shock absorber lower mounting bolt and nut. Remove the rear brake caliper/bracket assembly from the swingarm. BOLTS COVER HOSE GUIDE CLAMP SCREW BOLT/NUT CALIPER/BRACKET ASSEMBLY SWINGARM
  …

• 548J***DSINGLE PACKAGE ROOFTOPHEAT PUMP UNITSWITH FIELD—INSTALLED ELECTRIC HEATSIZES 17 & 24 WITH PURONR(R—410A) REFRIGERANTSubmittal DataCertified to ISOUse of the AHRI CertifiedTM Mark indicates amanufacturer’s participation in the program For verification of certification for individual products, go to www.ahridirectory.org.9001DESCRIPTION548J***D units are one—piece, tw …

  Magna VF750C 12

• OWNER’S SERVICE MANUALMANUEL D’ATELIER DU PROPRIETAIREFAHRER-UND WARTUNGS-HANDBUCHMANUALE DI SERVIZIO DELPROPRIETARIOYZ125(T)/T11C3-28199-30PRINTED IN JAPAN2004.5—2.5 × 1 !(E, F, G, H)YAMAHA MOTOR CO., LTD.2500 SHINGAI IWATA SHIZUOKA JAPANPRINTED ON RECYCLED PAPERYZ125(T)/T11C3-9-30 hyoshi 28/5/04 4:46 PM Page 1 …

  YZ125(T)/T1 568

• The owner’s manual contains assembly, use and maintenance instructions. The Kid Trax Motorcycle must be assembled by an adult who has read and understands the instructions in this manual. Keep the packaging away from children and dispose all packaging before use. 4902 Hammersley Rd. Madison, WI 53711 United States of America Phone: (877) 741-6154 www.kidtraxtoys.comModel Num …

  KT1058WM 24

You can only view or download manuals with

Sign Up and get 5 for free

Upload your files to the site. You get 1 for each file you add

Get 1 for every time someone downloads your manual

Buy as many  as you need

Посмотреть инструкция для Honda CBR125RW (2007) бесплатно. Руководство относится к категории мотоциклы, 2 человек(а) дали ему среднюю оценку 7.3. Руководство доступно на следующих языках: английский. У вас есть вопрос о Honda CBR125RW (2007) или вам нужна помощь? Задайте свой вопрос здесь

Главная

Не можете найти ответ на свой вопрос в руководстве? Вы можете найти ответ на свой вопрос ниже, в разделе часто задаваемых вопросов о Honda CBR125RW (2007).

Не нашли свой вопрос? Задайте свой вопрос здесь